Operation - Makita LM2300 Instruction Manual

• If the electric lawn mower is used while grass cuttings
and other dirt are blocking the inside of the main unit,
the over current relay will operate, automatically
stopping the device. In such cases, unplug the power
cord from the power socket, clean out the material
causing the blockage, press the Recovery Button, and
then restart mowing.
• Be sure to press the Recovery Button at least ten
seconds after the device has stopped.
NOTE:
• The over current relay may be activated when wet or
long grass gets caught up inside of the main unit.
Connecting Extension Cord (available in
market)
WARNING:
When connecting extension cord to the power supply
cord, make sure the Power Switch is OFF and the
cord is unplugged from the power socket.
• If the power connection is made with the Power Switch
ON, the device will start operating suddenly, which may
cause an accident.
• When connecting the extension cord to the power plug
of the main unit of the device, be sure to insert the
cord's plug fully.
2
• When connecting the extension cord, hook it over the
support hook as shown in the figure, to prevent
inadvertent unplugging, but make sure there is no
excessive strain on the plug connection.
Waist Hook for Power Cord
CAUTION:
Do not attach any item other than the extension cord
to the holder section of the waist hook for power
cord.
• Using the waist hook for power cord for purposes other
than intended may cause an accident and/or injury.
6
1. Over current
relay
1
1. Hook
2. Extension cord
1
1
2
3
1
2
• Using the waist hook for power cord helps prevent
careless severing of the extension cord due to the cord
being loose.
• Hook the hook section of the waist hook for power cord
into clothing or belt at waist height.
• To use the Waist Hook for Power Cord, place the
holder in your hand, and hook the hooked section (A
section) into clothing or belt at waist height, and then
clip the power cord into the holder with one touch.
• Be sure to clip in and clip out the power cord from the
mouth of the holder.
1
2
NOTE:
• Do not apply excessive strength to the mouth of the
holder. Doing so may cause misshaping or damage to
the holder.

OPERATION

Mowing
1. Hook
2. Waist hook
3. Holder
1. A section
2. Holder
1. Holder
2. Power cord