Page 1
This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
Page 3
ENCORE S2426 and L2426 Section II Parts and Service Manual (70200A) U.S. Patent No. 6,557,207 CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -25-...
Have an authorized service person repair the The charger is damaged. charger. Check voltage of each cell while discharging. The battery is defective. Connect the batteries. The batteries are disconnected. Adjust Pressure. Brush is in heavy scrub setting. Page -26- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 5
Turn key or switch on. Check the battery connections. Batteries are unplugged. Battery terminals are dirty. Batteries are discharged Check battery gauge and recharge NOTE: If the problem continues consult an authorized service person. CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -27-...
Page 22
CLARKE TECHNOLOGY Encore S2426/ L2426 Brush Head Assembly Drawing 1/03 Drawing #10071A and 10061A -44- CLARKE TECHNOLOGY Operator's Manual -Encore S2426 / L2426...
Page 23
980603 Washer, #10 Page 24 Brush/Pad Assemblies 80108A Screw, 10-24 x ½ 30092A Insulator, Mylar * Used only as required to square up linkage bar #14 to the 77091A Label, Moving Parts frame. CLARKE TECHNOLOGY Operator's Manual -Encore S2426 / L2426 -45-...
Page 25
NOTE: Only use spacer (ref. #2) on transaxles that have a circular step and mounting nuts protruding from end of motor. The motor that uses the spacer can be identified by the motor brush caps protruding past the outside diameter of the motor. CLARKE TECHNOLOGY Operator's Manual -Encore S2426 / L2426 -47-...