Page 1
ENCORE S2426 and L2426 Section II Parts and Service Manual Order Parts Here: www.ivie-ent.com/parts Ph:(918)254-5161 (70200A) CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -27-...
Have an authorized service person repair the The charger is damaged. charger. Check voltage of each cell while discharging. The battery is defective. Connect the batteries. The batteries are disconnected. Adjust Pressure. Brush is in heavy scrub setting. Page -28- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 3
Key or switch is off. Batteries are unplugged. Check the battery connections. Battery terminals are dirty. Check battery gauge and recharge Batteries are discharged NOTE: If the problem continues consult an authorized service person. CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -29-...
Page 19
Nut, -16 ESNA 87031A Washer, Flat Solution Tank 980205 Washer, 85734A Screw, -16 x 2 69639A Strap, Static 10135A Hub, Transaxle (includes #9) 77267A Label, Tie Down 81108A Nut, -24 ESNA CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -45-...
Page 20
CLARKE TECHNOLOGY Encore S2426/L2426 Brush Head Assembly Drawing 8/00 Drawing #10071A and 10061A Page -46- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 21
980603 Washer, #10 Page 24 Brush/Pad Assemblies 80108A Screw, 10-24 x ½ 30092A Insulator, Mylar * Used only as required to square up linkage bar #14 to the 77091A Label, Moving Parts frame. CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -47-...
Page 23
NOTE: Only use spacer (ref. #2) on transaxles that have a circular step and mounting nuts protruding from end of motor. The motor that uses the spacer can be identified by the motor brush caps protruding past the outside diameter of the motor. CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -49-...
Page 24
CLARKE TECHNOLOGY Encore S2426/L2426 Vacuum Motor Drawing and Parts List Drawing 5/00 Page -50- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 25
Ring, Snap 507641 Seal, Oil, Small 52050A Cap End 56668A O-Ring 51176a Bearing, Large 58316A Shaft & Gear 902605 Bearing, Small 54883A Housing 58144A Seal, Oil Large Darina EP2 Grease 4 oz. CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -51-...
Page 26
Brush Spring 40826A Brush Assembly 55657A Lead Assembly 55656A Lead Assembly Helical Washer 50515A Thru Bolt 80501A Shaft Key 54238A B.E. Bracket Assembly (Gear Box) * NOTE: Parts not available at this time. Page -52- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 27
CLARKE TECHNOLOGY Encore S2426/L2426 Transaxle Drawing 5/00 CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -53-...
Page 28
Strain Relief, D.C. Cord 747553 747553 D.C. Cord Assembly 51986A 51986A A.C. Cord Assembly 51974A 908947 Housing, Red 911470 911470 D.C. Plug Lock Key 795020 795020 * NOTE: Parts not available at this time. Page -54- CLARKE TECHNOLOGY Operator's Manual -Encore S2426/L2426...
Page 29
CLARKE TECHNOLOGY Encore S2426 Connection Diagram (00932A-W) 6/00 CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -55-...