Table of Contents
Advertisement
4-CH H.264 Network Video Recorder with HDMI
User's Manual of NVR-420
By default, the selection focus should be on "Channel 1' on the Channel List. The
side bar is basically divided into three sections. At any point, you can use the
"Left" or "Right" button on the remote control to quickly move to each section.
For example, if the selection focus is currently on "Channel 1" (or anywhere in
section "1"), press the "Left" button on the remote control to move the focus to
the "Manual recording" icon in section "2". Simply use the "Up" and "Down"
buttons on the remote control to move between icons in one particular section.
Use the "Up" and "Down" buttons on the remote control to select a channel on
the "Channel List" and press the "ENTER" button on the remote control to make
the selection. Alternatively, if a USB mouse is connected to the NVR, you can use
the mouse and move the cursor to a channel and left-click to make the selection.
You can also use the channel selection buttons on the remote control to quickly
jump to a desired channel.
The small dots on the side of the "Channel List" provide the current status of
each channel:
* White: Disconnected
* Blue: Connected
* Green: Recording
* Dark grey: Not configured
7.1.5 Sequence Viewing
If the current selection focus is on "Channel 4", press the "Down" button on the
remote control to move the focus to the "Sequence viewing" icon. Press the
80
Advertisement
Table of Contents
