Pontiac 2004 Aztek Getting To Know Manual page 5

• OFF turns off the DIC display three
seconds after it is selected. Press
the MODE button to turn the display
back on
The DIC can memorize personalized
settings for up to two drivers. A corre-
sponding Remote Keyless Entry System
transmitter identifies each driver. Using
a key to access the vehicle leaves set-
tings personalized for the last driver in
the vehicle.
Personalizing the DIC
• Enter Programming Mode by turning
the ignition key to ON with the
transmission in PARK
• Repeatedly press and release the
MODE button until PRESS SET TO
BEGIN PERSONALIZATION is
displayed
• Press the SET button. On the display,
TO SELECT DRIVER PRESS
REMOTE LOCK appears
• Press the LOCK button on your key
fob transmitter. This identifies you
with the key fob signal and, if key fob
transmitter #1 is being used, identi-
fies the transmitter number by dis-
playing PERSONALIZATION FOR
DRIVER 1. If key fob transmitter #2
is being used, the DIC identifies the
transmitter number by displaying
PERSONALIZATION FOR
DRIVER 2
• The PROGRAM MODE message in
the display center indicates that it is
ready to begin programming
Follow the DIC instructions on the
display to personalize each of the
following:
• Headlamp exit delay
• Interior lighting delay
• Interior lighting on
• Auto door lock/unlock
• Delayed locking
• Remote door unlock
• Lock/unlock feedback
Exiting Programming Mode
When you have reached the end of the
entire personalization list by pressing
the MODE button, the PERSONALIZA-
TION SELECTION DONE message
appears on the DIC display, followed by
PRESS SET TO EXIT MODE TO CON-
TINUE. To go back through the list
again, press MODE. If you are satisfied
with your settings, press SET. Your can
also exit programming mode by:
• Shifting the vehicle out of PARK (P)
• Turning the ignition key out of the ON
position
• Not programming any commands for
one minute, while in the programming
mode
Note: If equipped with DIC, when the
outside temperature is below 38°F, the
display will flash between "ICE" and the
current temperature for two minutes
after starting the vehicle. This safety
feature warns of possible icy conditions
and that caution should be taken when
driving.
See Section 3 of your Owner Manual.
5