Sliding Rear Convenience Tray; Adjusting The Roofrack Crossrails - Pontiac 2004 Aztek Getting To Know Manual

gate or by pressing REAR on the
Remote Keyless Entry System key fob
transmitter.
When the liftgate is
opened, reach inside
the tailgate to lift the
handle and open the
tailgate. To close them,
always close the tail-
gate first. Closing the
liftgate first can result in damage or
breakage.
See Section 2 of your Owner Manual.

Sliding Rear Convenience Tray

(optional)
This feature makes it easier to load,
organize and remove items from the
rear of your vehicle. To use this feature:
• Push the release lever located in
front of the handle of the tray to
release it from the floor assembly.
• Pull the tray toward you until you
hear a click, indicating the tray is in
the extended locked position.
• Push the release lever again and roll
the tray back into the vehicle until
hearing a click, indicating the tray's
locked position.
Note: Under normal driving conditions,
the tray's latching mechanism provides
sufficient retention. However, the tray's
tether strap provides added safety in
the event of a collision. The strap
does not affect the tray's ability to be
maneuvered into the vehicle or over the
tailgate.
See Section 2 of your Owner Manual.
Adjusting the Roof Rack
Crossrails
If your vehicle is equipped with a sun-
roof, you will need to first remove the
sunroof stop in order to adjust the roof
rack crossrails. To remove the sunroof
stop, use the special tool located in the
glove box, and then:
• Place the tool on the screw located in
the side rail assembly in front of the
crossrail.
• Remove the screw and repeat for the
other side.
• Put the tools and screw back in the
plastic bag in the glove box.
Adjusting the Rails:
• Lift the release lever on each side of
the crossrails (unlocked position).
Slide the rails forward or backward to
accommodate various size loads as
needed.
• Engage the release lever to lock the
rails in place.
Replacing the Sunroof Stop:
• Place the rear crossrail in the fully
rear position.
• Move the front crossrail rearward of
the sunroof stop screw hole. Put the
screws back into each siderail
assembly.
Important: Do not open the sunroof (if
equipped), if the crossrails are not in
the fully rear position, as damage could
result to the sunroof glass panel and/or
crossrails.
See Section 2 of your Owner Manual.
13