Installation; Route The Engine Harness - Yanmar BY series Installation Manual

This book represents a stern drive installation, because there are more items involved to install. Marine
gear (inboard) installations are similar but have less parts.
The tasks that must be completed to hook up the BY Classic Control Systems are as follows (This section takes
you through each task area).
•
Route the CE500XX engine harness from the engine area to the helm and install and connect the items that
are attached to the transom.
•
Route the shift cable from the engine area to the helm.
•
Install battery switch and engine breaker.
•
Install the engine.
•
Connect the items in the engine area.
•
Install the shifter and the tachometer.
•
Install the remaining helm components.
•
Connect the items at the helm.
•
Check out the installation.
Warning: Make all connections in accordance with applicable codes and standards.
Route the CE500XX Engine Harness
Mount the stern drive transom plate, gear lube reservoir, and trim pump per the stern drive instructions.
Page  Electronic Control System: Installation Manual for BY Series Engines with Classic Controls
Gear Oil

Installation

Trim Pump