Route The Shift Cable - Yanmar BY series Installation Manual

Run the engine harness from the helm to the transom area. The engine harness has three main connection
points, the helm, the transom and the engine.
CE500xx Helm End
Attach the transom breakout point to the transom near the centerline of the engine and high enough that you can
access this point after the installation is complete. Make the following connections and dress the wires.
•
Gear Oil Return (Black) and Gear Oil (Brown) connect to the Gear Oil Reservoir. Tie back when using
Marine Gear.
•
Trim Position Return (Black) and Drive Trim Position (Dark Blue) connect to wires from the transom plate.
Tie back when using Marine Gear.
•
Fuel Return (Black) and Fuel (Pink) go to the fuel sender.
•
Tie the J7 NMEA connector back at this time. This connector is supplied for future NMEA 2000 connections.
Leave the helm end and the engine end disconnected at this time.

Route the Shift Cable

Mount the shift plate that came with the stern drive near the stern drive transom plate and route the shift cable from
this area to the helm where the control will be mounted. Connect the stern drive lower leg cable and the cable that
goes to the shift control. The upper cable goes to the helm and the lower cable goes to the stern drive.
Electronic Control System: Installation Manual for BY Series Engines with Classic Controls
Installation
CE500xx Transom Breakout
Shift Plate
CE500xx to Engine
Page