Maintenance; Changing Engine Oil - Princess auto 2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER User Manual

8384281
RINSING WITH THE PRESSURE WASHER
1. Select and install the appropriate spray tip as described in the
USING AND SELECTING SPRAY TIPS section of this manual.
2. Test a small area first to avoid surface damage.
3. Rinse from top to bottom using long, overlapping strokes.
MOVING THE PRESSURE WASHER
1. Turn the pressure washer off.
2. Tilt the unit towards you until it is balanced on its wheels.
3. Roll the machine to desired location.
POST-OPERATION CHECKLIST
Follow the following procedures after each use:
• Shut off the engine and turn off the water supply. Release the
water pressure by pointing the spray gun in a safe direction
and squeezing the trigger.
• Disconnect the high pressure hose, spray gun, and nozzle.
Drain the water from items and use a rag to wipe down the outside of the hose and spray gun.
• Empty the water from the pump by pulling the recoil starter 6 times.
• store the unit in a clean and dry location.

MAINTENANCE

Regular maintenance will extend the life of this pressure washer and improve its performance. The warranty does
not cover items that result from operator negligence, misuse, or abuse.
WARNING! Never operate this unit if there are any broken or missing parts and only use recommended
replacement parts specifically designed for this unit.
• Always repair this unit as specified in this manual. If you have any questions contact your dealer or consult a
qualified service centre.
• Never modify this unit in any way or modify the governed speed.
REMOVE DEBRIS
• Clean any debris that has collected around or behind the muffler, cleaning system, and controls.
• Use a damp cloth to wipe the exterior surfaces. if dirt is caked on, use a soft bristle brush.

CHANGING ENGINE OIL

Engine oil will drain better if the engine is still warm, but not hot.
1. Shut off the engine.
2. Clean the area around the oil fill cap / dipstick to keep out debris, and then remove the oil fill cap / dipstick.
3. Place an oil pan on the ground to catch the oil. Remove the oil plug then tilt the pressure washer back and to
the side to empty out the oil from the crankcase.
4. Once the oil is completely drained, return the pressure washer to a level position and refill with new oil as
instructed earlier in this manual under the ADDING / CHECKING ENGINE OIL section.
CHECKING DETERGENT SIPHONING TUBE
1. Check the detergent siphoning tube for clogs, leaks, or tears.
2. Make sure the tube fits tightly to the pump fitting.
3. Replace the siphoning tubes if damaged.
For technical questions call: 1-800-665-8685
2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER V 2.0
FIG. 14
15