Table of Contents
Advertisement
Available languages
Available languages
V 2.0
•
Avoid contacting hot areas of this unit. Use caution around the muffler and other engine parts as they can be
very hot. Allow hot components to cool before touching.
•
Do not bypass any safety device. Moving parts are covered with guards. Make sure all protective covers are
in place.
•
Inspect hoses and connections making sure they are secure before starting the engine.
•
Use only recommended accessories to avoid damage to this unit.
•
Never carry this unit or make adjustments on it while it is running.
•
Spray from this unit has extreme pressure and can ricochet back splashing water or propelling objects
at eyes.
•
Never substitute eye protection with dry condition goggles.
TOOL USE AND CARE
•
Use the correct tool for the work. The proper tool will do the work faster and safer.
•
Do not use the tool if the On/Off switch is not working. Operating a tool that cannot be controlled by you is
dangerous and must be repaired before use.
•
Always turn the unit off before storing the tool, making adjustments or adding/replacing accessories. This
simple prevention will reduce the risk of accidental starting the tool.
•
Store the tool in a secure place out of reach of children. A secure storage location will prevent the
unauthorized use by untrained users.
•
Properly maintain tools. Keep all tools clean. Remove contaminants from the tool and keep clean. Check for
broken parts or binding of moving parts before use. If damaged, have the tool serviced before use. Prevent
accidents caused by poorly maintained tools.
•
Use only accessories recommended for your model. Accessories suitable for one tool may become
hazardous when used on another tool.
LUBRICATION
1. It is important that the tool be properly lubricated. Without proper lubrication the tool will not work properly
and parts will wear prematurely. Avoid over-lubricating the tool.
2. Use the proper lubricant to lubricate parts only as necessary. Use only recommended lubricants. Substitutes
may harm the rubber compounds in the tool's O-rings and other rubber parts.
3. Lubricate before storing. In the event that it becomes necessary to store the tool for an extended period of
time (overnight, weekend, etc.,) it should receive a generous amount of lubrication at that time.
WARNING! NEVER use WD-40 to clean or lubricate your tool. WD-40 is a solvent that will break down the
internal grease and cause the tool to seize up.
CHANGING THE PUMP OIL
•
Check engine oil level often. The first oil change should occur after the first 50 hours of use. Subsequent oil
changes should occur after every 500 hours of use.
•
Engine oil will drain better if engine is still warm but not hot. To change oil, turn off engine. Place an oil pan
on the ground to catch the oil. Remove oil plug and tilt machine back and to the side to empty out oil from
the crankcase. Once oil is completely drained, reinsert oil plug and return the machine to a level position.
UNPACKING
•
Remove the high pressure hose from the box.
•
Once the high pressure hose has been removed, carefully open the product by cutting down the sides
of the box.
•
Remove the product, parts, and all accessories. Make sure all items listed on the packing list are included.
•
Inspect the parts carefully to make sure the tool was not damaged while shipping.
•
Do not discard the packaging material until you have carefully inspected and satisfactorily operated the tool.
6
2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER
For technical questions call: 1-800-665-8685
8384281
Advertisement
Table of Contents
