Installation; Installing The Handle - Princess auto 2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER User Manual

8384281

INSTALLATION

ATTACHING THE WHEEL ASSEMBLY
1. Parts needed – 2 wheels, axle pins, and 2 cotter pins.
2. Remove the cotter pins from the wheel axle pins.
3. Slide the wheel axle pin through the hole located in the centre
of the wheel.
4. Raise or tilt the pressure washer so you can slide the
wheel axle pin into the wheel mounting hole located
on the side of the frame.
5. Secure the wheel assembly by reinserting a cotter pin through
the hole at the end of the wheel axle and pressing until it locks
into place.
6. Repeat the process on the other side of the pressure washer
to install the second wheel.

INSTALLING THE HANDLE

1. Install the upper frame (handle) onto the lower frame by
sliding the handle over the two upright tubes on the lower
frame and pressing down firmly until seated.
2. Align the upper and lower frame carriage bolt holes and
install 2 carriage bolts and 2 acorn nuts provided.
3. Tighten with a wrench until the upper frame tube begins to
crush slightly, securing the nut and the tubing.
ADDING / CHECKING ENGINE OIL
WARNING! Oil must be added to the unit prior to the first use.
1. Place the pressure washer on a level surface.
2. Unscrew the oil cap / dipstick by turning it counter clockwise.
3. Carefully add between 900 to 1,000 ml (33 to 33 oz)
of 4-Cycle engine oil (SAE10W-30) to the reservoir to where
the oil reaches the upper level of the oil filler neck.
4. Replace the oil cap / dipstick by turning it clockwise until it is
tightened.
5. To check the oil, set the pressure washer on a level surface,
wipe the dipstick clean, and then reinsert the dipstickwithout re-threading.
For technical questions call: 1-800-665-8685
2.3 GPM @ 2,600 PSI GAS PRESSURE WASHER V 2.0
FIG. 1
FIG. 2
9