Setting The Clock To Stamp The Recorded Time - Sony MZ-B3 Operating Instructions Manual

Setting the clock to
stamp the recorded
time
To stamp the date and time on the MD
when you record, you first need to set
the clock. When you use the recorder
for the first time or after a long period
of disuse, charge the built-in battery
for the clock after setting the clock
(page 18).
=
+
p
CLOCK SET
(
Battery
(on the
compartment
bottom)
(on the
bottom)
1
Connect the power source.
Install three size AA (LR6)
batteries.
2
Press CLOCK SET on the bottom
of the recorder.
Use a pointed object.
The digits of the year flash.
Year, month, and date
DATE AM
Current time
3
Enter the current year by pressing
= or +.
To change the digits rapidly, keep
pressing = or +.
4
Press (.
The year is set and the digit of the
month flashes.
DATE
AM
5
Repeat steps 3 and 4 to enter the
current month, date, hour, and
minute.
When you press ( to set the
minute, the clock starts operating.
DATE
PM
DATE
PM
If you make a mistake while setting
the clock
Press p, and set the clock again from step
2. You can skip a step by pressing (.
On the clock display
To display the current time
When the recorder is not operating or
while recording, press DISPLAY
repeatedly until the current time
appears in the display. The time
indication disappears after 10 seconds.
To display the time in the 24-hour system
While setting the clock, press DISPLAY.
To display the time in the 12-hour
system, press DISPLAY again.
Continue to next page m
SONY MZ-B3 (E) 3-798-610-22(1)
17