Speaker Setting - Kenwood KDC-MP5032 Instruction Manual

Adjustment Item Display
2
Front High Pass Filter* "HPF"
2
Rear High Pass Filter* "HPR"
1,2
Low Pass Filter* "LPF"
1,2,3
Subwoofer Phase* "PHAS"
Volume offset "V-OFF"
Loudness "LOUD"
Dual Zone System "2ZON"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
When Loudness is ON, "LOUD" indicator
is ON.
• * 1 You can control this item when <Subwoofer
Output> (page 12) is set to "SW ON".
2
• * You can control this item when "2ZON" of <Audio
Setup> (page 10) is set to "OFF".
3
• * You can control this item when Low Pass Filter is not
set to Through.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 24).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 10).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Option CA-C1AX/ CA-C2AX
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/
Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0
OFF/ON
OFF/ON

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6x9/6"
For the OEM speaker "SP OEM"
4
Exit Speaker Setting mode
Press the [VOL] knob.
11
|
English