Table of Contents
Advertisement
General features
"Bass" : Adjust the bass level.
Setting values: - 8 – + 8
"M id" : Adjust the middle level.
Setting values: - 8 – + 8
"Treble" : Adjust the treble level.
Setting values: - 8 – + 8
"Balance" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Fader" : Adjust the fader level.
Setting values: Rear 15 – Front 15
"V OFFSET" : Set the sound level of the each source selected by
adjusting the level difference betw een the basic
sound level and the required level.
Setting values: - 8 – ± 0
"SYS-Q" : < System Q > Recalling the kenw ood preset sound
setting
Press the preset buttons (#1-6).
Settings:#1;Flat ( ' SYS-Q Flat " ), #2;Rock ( ' SYS-Q Rock " ),
#3;Top 40 ( ' SYS-Q Top40 " ), #4;Pops ( ' SYS-Q Pops " ),
#5;Jazz ( ' SYS-Q Jazz " ), #6;Easy ( ' SYS-Q Easy " )
N OTE
The System Q function changes the values of the follow ing
sound quality parameters:
Bass centre frequency, bass level, bass quality factor, bass
extend, middle centre frequency, middle level, middle quality
factor, treble centre frequency, and treble level.
Their setting values are different depending on the setting of the
speaker setting mode.
Speak er Set t ing
This function allow s you to adjust the setting that is recalled
w ith the System Q, according to types of speakers.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed w hen the standby mode is selected.
2
Press the AUD button to enter the speaker setting mode.
3
Press either the 4 or ¢ button to select the type of
speaker. The setting sw itches as follow s.
Off ("SP OFF") / For the OEM speaker ("SP OEM ") / For 6/6x9
in. speaker ("SP 6/6x9inch") / For 5/4 in. speaker ("SP 5/4inch")
4
Press the AUD button to end the speaker setting mode.
N OTE
Speaker setting function allow s for tuning of bass, middle and
treble
Thef t D et errent Faceplat e
The faceplate of the unit can be detached and taken w ith you,
helping to deter theft.
Projections
Grooves
— 8 —
Release button
Advertisement
Table of Contents
