Built-In Amp Setting; Dual Zone System Setting; Supreme Setting; Crsc (Clean Reception System Circuit) - Kenwood KDC-MP5032 Instruction Manual

Menu system
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP ON" The built-in amplifier activates.
"AMP OFF" The built-in amplifier deactivates.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel
sound in the Dual Zone System.
Display Setting
"ZONE2 R" Sub source (Auxiliary input source) is to be rear
channel.
"ZONE2 F" Sub source (Auxiliary input source) is to be front
channel.
In Audio file source

Supreme Setting

When AAC, MP3 or WMA files encoded at a low
bit rate (less than 96kbps (fs=32k, 44.1k, 48kHz))
are played, this function restores their high
frequency region to approach the sound quality
of equivalents of these files encoded at a high bit
rate. Processing is optimized for the compression
format used (AAC, MP3, or WMA), and adjustment
is made for the bit rate used.
Display Setting
"SPRM ON" Plays sound using the Supreme function.
"SPRM OFF" Plays the original sound stored in the audio file.
• The sound effect may be imperceptible depending
on the relationship between the audio file format and
setting.
24
|
English
In FM reception
CRSC (Clean Reception System
Circuit)
Temporarily have reception alternate from
stereo to mono to reduce multi-path noise when
listening to the FM station.
Display
"CRSC ON"
"CRSC OFF"
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned
ON. In such a situation, turn it OFF.
In HD Radio mode

Receive mode Setting

Sets the receive mode.
1
Select the Receive mode
Push the Control knob towards [FM] or [AM].
Select the "HDR MODE" display.
2
Enter Receive mode
Press the Control knob for at least 1 second.
3
Set the Receive mode
Push the Control knob towards [FM] or [AM].
Each time you push the knob, the Receive mode
alternates between the modes shown in the
table below.
Receive mode Display
Auto mode "AUTO"
Digital "DIGITAL"
Analog "ANALOG"
4
Exit Receive mode
Press the [MENU] button.
• Even if the Receive mode is set to "AUTO", when the
Ball game mode program (non-delayed broadcast
program) is received, the Receive mode will
automatically switch to Analog broadcast only.
Setting
The CRSC is ON.
The CRSC is OFF.
Operation
Analog broadcasts and digital
broadcasts will be switched
automatically.
When both are being transmitted,
the digital broadcast will have
priority.
Digital broadcasts only.
Analog broadcasts only.