Connecting Wires To Terminals - Kenwood KDC-MP2035 Instruction Manual

Connecting Wires to Terminals

To Kenwood disc changer/ External optional accessory
(KDC-MP2035/MP235 only)
⁄
To connect these leads,
refer to the relevant
instruction manuals.
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control
terminal when using the optional power
amplifier, or to the antenna control
terminal in the vehicle.
Connect to the terminal that is grounded
when either the telephone rings or
during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
⁄
Do not let the wire come out from
the tab.
To front right speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery +
26
|
English
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
Purple
Car fuse box
–
Rear left output / Sub Woofer left output (White)
Rear right output / Sub Woofer right output (Red)
(KDC-MP2035/MP235/MP205 only)
Rear left output (White)/ Rear right output (Red)
(KDC-MP235CR only)
FM/AM antenna input
Power control/Motor antenna control wire
(Blue/White)
P.CONT
TEL mute wire (Brown)
MUTE
Not Used (Blue)
ANT.
CONT
ACC
Ground wire (Black) - (To car chassis)
Front right output (Red)
(KDC-MP2035 only)
Front left output (White)
(KDC-MP2035 only)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)