Connecting Wires To Terminals - Kenwood K-CD01 Instruction Manual

Connecting Wires to Terminals

Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
FM/AM antenna input
If no connections are made, do not let the
wire come out from the tab.
When using the optional power amplifier, connect to its
power control terminal.
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
To "EXT.AMP.CONT. " terminal of the amplifier having
the external amp control function.
Do not let the wire come out from
the tab.
Car fuse box
(Main fuse)
Battery
22
|
English
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
Subwoofer left output (White)
Subwoofer right output (Red)
Fuse (10A)
Wiring harness
(Accessory1)
P.CONT Power control wire (Blue/White)
ANT CONT Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
External amplifier control wire
(Pink / Black)
Not Used (Brown)
MUTE
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
ACC
Car fuse box
Ground wire (Black) - (To car chassis)
To KENWOOD disc changer/
LX BUS Television/
External optional accessory
To connect these leads,
refer to the relevant
instruction manuals.
Ignition wire (Red)
Battery wire (Yellow)