SonicWALL SSL-VPN 2000 Administrator's Manual page 90

Booting a Firmware Image
To boot a firmware image, perform the following steps:
Click the boot icon
Step 1
SonicWALL SSL-VPN appliance.
The pop-up message is displayed: Are you sure you wish to boot this firmware? Click OK.
Step 2
Uploading New Firmware
To upload new firmware, perform the following steps:
Login to MySonicWALL.
Step 1
Download the latest SonicWALL SSL VPN firmware version.
Step 2
In the SonicWALL SSL VPN management interface, navigate to System > Settings page.
Step 3
Click the Upload New Firmware button under the Firmware Management section.
Step 4
Click Browse.
Step 5
Select the downloaded SonicWALL SSL VPN firmware. It should have a .sig file extension.
Step 6
Click Open.
Step 7
Click Upload.
Step 8
The SonicWALL SSL-VPN appliance will automatically reboot when the new firmware has been
Step 9
uploaded.
Creating a Backup
To create a system backup of the current firmware and settings, click the Create Backup
button. The backup may take up to two minutes. When the backup is complete, the Status at
the bottom of the screen will display the message "System Backup Successful."
The Create Backup button is only available on the SonicWALL SSL-VPN 2000 and 4000.
Note
next to the Firmware Image version that you want to run on the
SonicWALL SSL VPN 4.0 Administrator's Guide
System > Settings
77