SonicWALL SSL-VPN 2000 Administrator's Manual page 106

To configure these settings for an interface on the SonicWALL SSL-VPN appliance, perform the
following steps:
Navigate to the Network > Interfaces page and click the configure icon next to the interface
Step 1
you want to configure.
In the Edit Interfaces dialog box on the SonicWALL SSL-VPN appliance, type an unused static
Step 2
IP address in the IP Address field. This IP address should reside within the local subnet to
which your SonicWALL SSL-VPN appliance is connected.
Type Subnet Mask in the corresponding field.
Step 3
On SonicWALL SSL-VPN models 2000 and higher, in the IPv6 address/prefix field, optionally
Step 4
enter an IPv6 address for global scope. If you leave this field empty, IPv6-enabled devices can
still automatically connect using a link-local address. The scope is indicated in a tooltip on the
Network > Interfaces page.
In the Speed drop-down list, Auto Negotiate is selected by default to allow the SSL-VPN
Step 5
appliance to automatically negotiate the speed and duplex mode with the connected switch or
other networking device. Ethernet connections are typically auto-negotiated. If you want to
force a certain link speed and duplex mode, select one of the following options:
100 Mbps - Full Duplex
–
100 Mbps - Half Duplex
–
10 Mbps - Full Duplex
–
10 Mbps - Half Duplex
–
If you select a specific link speed and duplex mode, you must force the connection speed
Note
and duplex from the connected networking device to the SonicWALL security appliance as
well.
SonicWALL SSL VPN 4.0 Administrator's Guide
Network > Interfaces
93