Kenwood DP-4090 Instruction Manual page 6

6
SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connec-
tions according to the groups of terminal symbols shown below.
: lets you combine F, f, and ƒ terminals
[XS8] Mode
[SL16] Mode : for
This unit is compatible with both [XS8] and [SL16] modes.
Select the mode according to the connected components. 4
SL16 XS 8
÷ Do this operation after completing all connections.
(Ensure that the power is OFF.)
Notes Notes
1. If your amplifier or receiver does not have a system control terminal,
do not connect any system control cords to the system control ter-
minals on the other components.
2. Do not connect system control cords to any components other than
those specified by KENWOOD. It may cause a malfunction and dam-
age your equipment.
3. Be sure the system control plugs are inserted all the way in to the
system control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD. Also, the simple CCRS operation lets you make great recordings
from CD.
See the operating instructions supplied with your cassette deck for details.
terminals only
j
Amplifier or receiver
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
DP-5090/4090 (En)
This unit
Cassette deck