Timer Operations - Kenwood DP-4090 Instruction Manual

Timer operations

Timer playback of CD can be started at any time using an
audio timer which is available in audio stores.
20
Preparation
÷ Connect the power cords of the associated
components so that their power can be turned
ON through the audio timer.
(Also, be sure to read carefully the instruction
manual of the timer.)
1
Turn the powers of the associated components
ON.
2
Preparation
Load a disc in the CD player.
3
Set the amplifier volume.
1
2
3
4
Set the timer ON time.
Set the timer so that it supplies
power at the specified time.
5
Turn OFF the power output from the audio timer.
1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.
Notes Notes
2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.
Label side
Play the disc.
6
Adjust the amplifier volume.
Stop the disc.
7
This unit
System control cord
Amplifier
Audio timer
÷ If the amplifier is not connected to the CD player through a system
control cord, select the "CD" input with the input selector.
0
÷ With some audio timer models, the power is automatically turned OFF
when the timer ON time is set. With such a model, skip step 5 below.
÷ Do not touch the POWER switches of the amplifier and CD player.
÷ When the set time comes, the disc playback starts automatically.
DP-5090/4090 (En)
Audio cord
12 : 00
To wall AC outlet