To Check Or Change The Programmed Tracks; To Add A Track To The Program; To Clear Tracks From The Program - Kenwood DP-4090 Instruction Manual

To check or change the programmed tracks

1
Press the CHECK key.
CHECK
REMOTE CONTROL UNIT
RC-P0505
2
Select the new track No.
REMOTE CONTROL UNIT
RC-P0505
3
Set the entry.
P.MODE
REMOTE CONTROL UNIT
RC-P0505

To add a track to the program

1
Select the desired track No.
REMOTE CONTROL UNIT
RC-P0505
2
Press the P.MODE key.

To clear tracks from the program

Press to clear tracks from the end.
REMOTE CONTROL UNIT
RC-P0505
To clear all track.
REMOTE CONTROL UNIT
RC-P0505
Press until the track No. to
be changed is displayed.
1 2 3
4 5 6
7 8 9
0 +10
Remote control unit only
1 2 3
4 5 6
7 8 9
0 +10
Remote control unit only
CLEAR
P.MODE
Auto space function
During programming of tracks, a non-recorded space of a few
seconds will be automatically created between tracks. By re-
cording tracks with these spaces on tape, the search and repeat
play operations of tape using the DPSS function (which works
by searching the non-recorded spaces) can be performed reli-
ably.
÷ Even when the performances of two tracks are continuous (which
occurs with classical or live recording music), the spaces will be
created if they have different track Nos.
Remote control unit only
P G
÷ Perform only step 1 to simply check the program.
÷ In the case of a CD-TEXT disc, the track's title is scrolled on the display.
÷ Each time the key is pressed, the program No. and the track No. on CD
are displayed.
÷ Press it while the "PGM 01" indicator blinks.
÷ The track being played cannot be changed.
÷ When a track No. is selected, the track will be added to the end of the
existing program.
÷ Each time the key is pressed, the last track in the program is cleared.
÷ The tracks which are programmed earlier than the track being played
cannot be cleared.
÷ Selected tracks can be also completely cleared just by operating the 0
key.
÷ The entire program is cleared.
DP-5090/4090 (En)
Blinks.
M 1 0 T N O .
Example
15
2 5