Registration Of Dts Discs - Kenwood CD-4900M Instruction Manual

Registration of DTS discs

When playing DTS-encoded discs, excessive noise will be exhibited from the analog stereo outputs. If DTS discs are regis-
tered beforehand, the audio signal from the Player B (analog OUTPUT-B) is skipped. Use the following procedure before
28
playing the DTS disc.
Preparation
÷ Load DTS discs into the carousel.
÷ Check that the Player A is in the normal play
TRACK mode.
1
Activate the dts disc skip mode.
1 Press the MODE button.
MODE
2 Select "DTS DISC SKIP".
DISC SKIP
DOWN UP
2
Select "SET DTS DISC".
DISC SKIP
DOWN UP
3
Select the DTS disc.
Select the disc number.
DISC SKIP
DOWN UP
Previous disc
To delete the DTS registration
Use the following procedure before moving or changing a DTS disc, and register the disc again.
1 Perform steps 1 of "Registration of DTS discs".
2 Select "CANCEL DTS DISC".
DISC SKIP
DOWN
UP
3 Select the DTS disc to be deleted.
DISC SKIP
DOWN UP
Previous disc
When a DTS disc is played, the audio signal is not output at the analog OUTPUT A jacks.
Note Note
SET
\
SET
\
SET
\
Next disc
SET
\
SET
\
Next disc
&
)
÷ When the MODE button is pressed during DTS DISC SKIP mode, the
DTS DISC SKIP mode is cancelled.
Each press switches the modes as follows:
1 MUSIC TYPE
2 DISC SEARCH
3 TITLE INPUT
4 ALL DATA READ
5 ALL INFORMATION
6 DTS DISC SKIP
Each press switches the modes as follows:
1 SET DTS DISC
2 CANCEL DTS DISC
÷ The disc number can be selected directly by using the numeric keys in
place of the DISC SKIP (DOWN/UP) buttons.
÷ To register another DTS disc, repeat the procedure from step 3.
DISPLAY-A
D 0 0
To quit DTS DISC SKIP mode
Press the MODE button.
Each press switches the modes as follows:
1 SET DTS DISC
2 CANCEL DTS DISC
DISPLAY-A
D 0 0
To quit DTS DISC SKIP mode
Press the MODE button.
1 I D T S U S E T
1 I D T S U C A N
? A Y
C ? .