Registration Of Dts Discs - Kenwood CD-2280M Instruction Manual

Registration of DTS discs

Use the following procedure before playing the DTS disc.
Preparation
÷ Load DTS discs into the carousel.
÷ Check that the Mechanism-A is in the normal
play TRACK mode.
1
Activate the DTS ANALOG MUTE mode.
1 Press the MODE key.
2 Select "DTS ANALOG MUTE".
∞ DISC SKIP 5
2
Select "MUTE ON".
∞ DISC SKIP 5
3
Select the DTS disc.
Select the disc number.
∞ DISC SKIP 5
Previous disc
To delete the DTS registration
Use the following procedure before moving or changing a DTS disc, and register the disc again.
1 Perform steps 1 of "Registration of
DTS discs".
2 Select "MUTE OFF".
∞ DISC SKIP 5
3 Select the DTS disc to be deleted.
∞ DISC SKIP 5
Previous disc
When a DTS disc is played, the audio signal is not output at the analog output jacks.
Note Note
0
#
MODE
SET
\
SET
\
SET
\
Next disc
SET
\
SET
\
Next disc
: Keys and controls used in the operations described on this page.
÷ When the MODE key is pressed during DTS ANALOG MUTE mode, the
DTS ANALOG MUTE mode is cancelled.
Each press switches the modes as follows:
1 MUSIC TYPE
2 TITLE INPUT
3 ALL DATA READ
4 ALL INFORMATION
5 DTS ANALOG MUTE
Each press switches the modes as follows:
1 MUTE ON
2 MUTE OFF
DISPLAY-A
S E L E C T T
÷ The disc number can be selected directly by using the numeric keys in
place of the DISC SKIP keys.
÷ To register another DTS disc, repeat the procedure from step 3.
To quit DTS ANALOG MUTE mode
Press the MODE key.
Each press switches the modes as follows:
1 MUTE ON
2 MUTE OFF
To quit DTS ANALOG MUTE mode
Press the MODE key.
CD-2280M/DPF-J9010 (En)
D I S C S E M T
29