Argox Smart CP-2140 User Manual page 31

Compact printer series
Hide thumbs Also See for Smart CP-2140:
Table of Contents

Advertisement

Control /
Indicator
Power
Switch
Power LED
Ready LED
www.meteorbarcode.it - info@meteorbarcode.it
On: turns on normal operation (at "I" position)
Off: turns off power ( at "O" position)
Note: Turn power off before connecting or
disconnecting cables
It will start blinking while "Media Out", "Media
Gap Not Found" or "Ribbon Out" has been
detected.
Once printer cutter mode has been enabled,
when Cutter is jammed with paper or Cutter is
not installed, POWER indicator will blink.
When RS-232 communication error is
detected, POWER indicator will blink.
When printer is started, the READY indicator
will blink. In Ethernet model, the READY
indicator will blink for several seconds to wait
till Ethernet Card is ready.
When printer receives data from host PC,
READY indicator will start blinking.
READY indicator will blink when printing is
paused.
It will start blinking while "Media Out", "Media
Gap Not Found" or "Ribbon Out" has been
detected.
It will blink as soon as the printer module is
opened.
Function
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smart-e cp-2140e

Table of Contents