Argox Smart CP-2140 User Manual page 34

LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems
Ribbon out
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems
Serial IO error
Cutter has failed, or
there is paper jam
inside the cutter.
Other possible
hardware errors.
www.meteorbarcode.it - info@meteorbarcode.it
Solutions
Install a new ribbon roll Set "Direct Thermal"
Solutions
Check serial baud rate at
both of your system and
the printer.
Check the cutter or
recover paper jam.
Contact the reseller for
further service.
34
Remarks
printing by driver or
commands if no ribbon is
required.
Remarks
For serial interface only
Only applicable when
cutter mode to cutter
mode.