Table of Contents
Advertisement
◎ BOX CONTENTS
1. Charger
2. 7Cells Balance board/ Cable (EH to XH) 2 pairs
4. USB cable
5. OUT PUT cable with alligator clip 2 pairs
7. User manual
8. Warranty card
◎ SAFETY PRECAUTIONS
- Do not attach the charger to both of AC and DC power source at the same time.
- Never connect the input jack (DC input) toAC power.
- Make sure to disconnect the docking power supplier when to input DC power source to the
rear terminal of charge.
- Make sure to program the input power setup correctly at USER SETUP mode.
- Make sure to program the input power setup correctly at USER SETUP mode when to use
the docking power supplier.
- Be cautious about an automobile battery dead, when power source is supplied from an
automobile.
- Make sure to supply enough power source to charger. The charger output is maximum 400W for
each channel.
- If possible, put the battery in a safety bag when to charge or discharge.
- Make sure to pay attention to charger during use.
Disconnect the battery and remove input power from charger immediately if the charger becomes
hot and keep the charger and battery cool down before reconnecting.
- Do not attempt to charge dead or damaged batteries.
- Make sure to charge the pack consisted of the same type of batteries.
- Do not attempt to charge a battery pack containing different types of batteries.
- Do not use the too shot cable or damaged cable.
- Make sure to charge a pack for each channel.
- Do not use near a flammable object and use in a well ventilated area, the gas in explosion
possibilities may be generated during use.
- Do not reverse the positive and negative terminals. Wrong connection will damage the battery
and may cause damage to the charger.
- Make sure to use only rechargeable batteries and ensure them meet the requirements of this
charger.
- Do not allow water, moisture or foreign objects into the charger.
- Do not use in humid place and do not operate with wet hands.
- Do not attempt to dismantle the charger.
- Do not use on the fleecy material such as carpet, blanket, bed, cushion and make sure to use
in a hard and flat surface.
5
- Do not use in the too cold place or hot place, charge may not output normally or may not
be operated.
- Make sure to use in a well ventilated place and do not block the cooling fan (rear) and air
3. Temperature sensor 2pcs
inlet (front).
6. Charger rack
- Make sure to use in the proper place that you can see TFT panel since TFT panel might
not be visible under strong sunlight.
- We strongly recommend balancing a Lithium pack, An unbalanced pack can cause damage
and in extreme cases can cause a fire.
- Make sure to connect one battery pack to a balance board. If not, battery or charge can
get the damage.
- Charger do not charge the battery of which voltage is below 2.8V per cell. If the battery is
forced to charge, the pack can cause damage and in extreme cases can cause a fire
- The default charging current is 1C. Make sure to check the voltage and temperature of
battery when to charge with more than 1C.
- Do not charge Lithium Polymer battery packs at greater than 4.2V per cell.
- Always disconnect the battery after charging, and let the charger cool between charges.
6
Advertisement
Table of Contents
