Table of Contents
Advertisement
The optional accessory
Connection configuration for ESC, Motor, Battery, Wire splitter
It is for connection of charger side terminal.
The connector marked "sensor in the wire splitter is connected to motor and the left 2
connectors are connected to charge and ESC
ESC signal connector is connected to charge servo test socket
33
Wire splitter for testing motor sensor
(S8002)
Brushed motor setup
Connect motor to 4mm banana charge socket and tap MOTORicon to access motor setup mode
This page is consisted of 3 menus
1) Break-In
- Motor is operated and tamed with the preset voltage for the preset time
The operating time is set by minute, second
The operating voltage is set
Tap Enter button to check the operating time, voltage,
consumption current
2) Program
- There are 4 steps. Set voltage, operating time, delay time and number of cycle for
every 4 steps and tap Enter button. The charge will repeat to tame motor as many as
the preset number of cycle. The blue character shows the current process
34
Advertisement
Table of Contents
