Getting The Best Results; Fitting The Collar - Num'axes Canicom 5.201 Instruction Manual

How to check that your product is functioning properly
●
 Activate the receiver collar you want to test.
 Activate the remote control.
 Select the collar you want to test using the
On the CANICOM 5.202, CANICOM 5.500 and CANICOM 5.800 remote controls, the symbol

appears on the LCD screen.
On the CANICOM 5.1500 remote control, the symbol

screen.
For CANICOM 5.201, you don't have to select a collar because there is only one.

 Press the button on the remote control: the collar must emit beep sounds.
 Press the button on the remote control: the collar must vibrate.
 Put the all-in-one accessory in contact with the contact points located on the collar (ref. Diagram 8) and press
the button on the remote control: the test lamp inside the all-in-one accessory must light.
If you have several collars, renew the same procedure for each one.
Checking your product is

Getting the best results

●
The training instructions you send to your dog are sent from the remote control to the receiver collar by radio
waves.
These radio waves are sensitive and the range reaches approximately:
 200 meters for CANICOM 5.201 and CANICOM 5.202
 500 meters for CANICOM 5.500
 800 meters for CANICOM 5.800
 1500 meters for CANICOM 5.1500
The range depends on geography and environment.
The performances of your product will be optimal if you follow these recommendations:
To obtain a good radio range, do not cover the antenna or the part located above the LCD screen when you
▪
hold the remote control in your hand.
The position of the receiver collar around the neck of the dog should be in the following way: the indicator
▪
light on the collar is visible and is not in contact with the breast of the dog.
Check the batteries (remote control and receiver collar) before using the unit and replace them as soon as the
▪
level of load is weak.
The performances of the batteries decrease slightly under temperatures lower than 0°C. If possible, keep the
▪
remote control warm (e.g. inside a pocket) before using it.

Fitting the collar

●
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your dog.
▪
Furthermore, it will not function correctly.
If the collar is too tight, the dog will have breathing difficulties.
▪
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
Do not leave the collar positioned at the same place for long periods (i.e. over 3 hours) because this can cause
irritations. If your dog must wear the collar for long periods, change regularly the position on the neck of your dog.
CANICOM 5 range - user's guide– indice A
Diagram 8
operating properly
or button of the remote control.
1, 2, 3 or 4 appears on the LCD
1 or 2
9/12