Base Stand Assembly Instruction; Wall Mounting Installation Guidelines - AWA MHDV2262-O4 User Manual

Base Stand Assembly Instruction
Place the TV with the display side down on a flat surface. Ensure the table or desk you use provides
a flat, totally clean surface.
Use a cloth between the face of the TV and the table to protect the TV's screen.
1. Locate the bottom bracket into the gap in the bottom of the TV, and secure it using the supplied screw,
as per a) below.
2. Gently slide the now-affixed bracket at the bottom of the TV into the slot in the base stand. Secure
the base stand using the supplied thumb-screw, as per b) below.
a)

WALL MOUNTING INSTALLATION GUIDELINES

For wall mounting with an optional bracket, please read the following instructions in conjunction with the
bracket's instructions. Make sure qualified service personnel perform the operation.
This television can be wall mounted as follows:
1.Place the LED LCD Television face down onto a solid surface. Please place some soft material over
the front of the screen to protect it from any damage. The LCD panel is a fragile component, and must
be suitably protected when removing the base stand. Be sure that no hard or sharp objects can come
into contact with the screen's surface. Do not exert pressure on the front of the unit at any time, as this
may damage the LCD screen.
2.Remove the screw from the lower part of the television, where the base joins to the TV, and take
away the stand (put the stand and screw somewhere safe for future use).
3.Use the four M4 screws provided to fix the TV onto a wall mounting bracket (not included) via the
four VESA standard holes on the back of the television.
b)
100 mm
100mm x 100mm VESA
wall mounting hole spacing
100 mm
and locations
-6-
INSTALLATION
Thumb-screw