Base Stand Assembly Instruction; Wall Mounting Installation Guidelines - AWA MHDV4601-O3 User Manual

Base Stand Assembly Instruction
1. Place the TV with the display side down on a flat surface. Ensure the table or desk you use provides
a flat, totally clean surface. Use a cloth between the face of the TV and the table to protect the TV's
screen.
2. Gently slide the bracket from the base stand into the slot in the rear of the TV, aligning the hole in
the bracket with the hole in the TV. Secure the base stand using the supplied screw.

WALL MOUNTING INSTALLATION GUIDELINES

For wall mounting with an optional bracket, please read the following instructions in conjunction with the
bracket's instructions. Make sure qualified service personnel perform the operation.
AWA bears no responsibility for improper mounting that results in accident or injury.
This television can be wall mounted as follows:
1.Place the LED LCD Television face down onto a solid surface. Please place some soft material over
the front of the screen to protect it from any damage. The LCD panel is a fragile component, and must
be suitably protected when removing the base stand. Be sure that no hard or sharp objects can come
into contact with the screen's surface. Do not exert pressure on the front of the unit at any time, as this
may damage the LCD screen.
2.Remove the screw from the lower part of the television, where the base joins to the TV, and take
away the stand (put the stand and screws somewhere safe for future use).
3.Use the four M4 screws provided to fix the TV onto a wall mounting bracket (not included) via the
four VESA standard holes on the back of the television.
400 mm
400 mm
-6-
INSTALLATION
wall mounting hole spacing
and locations