Error Messages; Cleaning And Care - Silvercrest SBB 850 EDS A1 Operating Instructions Manual

Note
Do not use any metal objects which may cause
scratches on the non-stick coating.
After removing the bread, immediately rinse the
baking mould with warm water. This prevents
the kneading paddles
driving shaft.
Tip: If you remove the kneading paddles
the last kneading of the dough, the bread will
remain intact when you remove it from the
baking mould .
• Briefly press the Start/Stop button
the programme at the very start of the baking
phase or, remove the power plug from the wall
socket. Ensure that you re-insert the power plug
within 10 minutes so that the baking process can
be continued.
• Open the appliance lid
baking mould
with floured hands and remove the kneading
paddles .
• Lay the dough back into the baking mould
Replace the baking mould
appliance lid .
• Insert the power plug into the wall socket. The
baking programme continues from where it
was stopped.
Allow the bread to cool for 15-30 minutes before
eating it.
Before cutting the bread, ensure that the kneading
paddles have been removed
from sticking to the
to interrupt
and remove the
. You can take the dough out
and close the
.

Error Messages

• If the display
me has been started, it indicates that the tempe-
rature in the Bread Baking Machine is still too
high. Stop the programme and remove the power
plug. Open the appliance lid
chine to cool down for 20 minutes before re-
after using it.
• If a new Programme cannot be started directly
after the Bread Baking Machine has completed
a baking process, it means the appliance is still
too hot. In this case the display panel reverts to
the default setting (Programmme 1). Open the
appliance lid
down for 20 minutes before re-using it.
Warning
Do not attempt to take the appliance into use befo-
re it has cooled itself down. This functions only with
programmes 11 and 12.
• If the display shows "EE0", "EE1" or "LLL" after
. the programme has been started, first of all
switch the Bread Baking Machine off and then
back on by removing and then re-inserting the
power plug from/into the wall socket. Should the
error display continue, make contact with
Customer Services.

Cleaning and Care

Warning
Before cleaning it, always remove the power plug
from the wall socket and allow the appliance to
cool down completely.
Protect the appliance against moisture, this could
cause you to receive an electric shock.
Please also observe the safety instructions.
- 10 -
shows "HHH" after the program-
and allow the ma-
and allow the machine to cool