Operating Instructions; Starting Treatment; Stopping Treatment - ResMed S7 lightweight User Manual

O
PERATING
S T
TARTING REATMENT
The R M S7 L
ES ED
tubing and mask system connected. See "Setting Up The ResMed S7 Lightweight" on
page 9.
1
Turn the main power switch at the back of the unit to on (I).
When the R M
ES
the LCD screen. The Ramp screen then appears.
2
Fit your mask as described in the mask user instructions.
3
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
CAUTION
!
Do not leave long lengths of air tubing around the top of your bed. It could
•
twist around your head or neck while you are sleeping.
Make sure the area around the flow generator is dry and clean. It should also be
•
clear of bedding, clothes, and other potential blockages.
4
To start treatment, press the Front key.
If a ramp time is selected, the LCD will display the word RAMPING with set pressure
indicated as dashes. At the end of the ramping period the LCD will display CPAP.
After starting treatment, the LCD will look similar to one of the screens below.
CPAP
– – – – – –
The dashes represent the set pressure, where each dash is approximately equivalent
to 2 cm H O pressure. For example, 6 dashes represents approximately 12 cm H
2
pressure.
S T
TOPPING REATMENT
To stop treatment at any time, remove your mask and press the Front key.
I
NSTRUCTIONS
unit should be assembled beside your bed with the air
IGHTWEIGHT
S7 L
ED IGHTWEIGHT
is turned on, the software version is displayed on
RAMPING
– – –
O I
PERATING NSTRUCTIONS
O
2
17