Honda 2012 TRX420TM Owner's Manual page 121

6. Reinstall the oil filter cover, making sure the bolts are tightened to the
specified torque:
7 lbf·ft (10 N·m , 1.0 kgf·m)
7. Pour the drained oil into a suitable container and dispose of it in an
approved manner (page
Improper disposal of drained f luids is harmf ul to the environment.
8. Install the right side cover.
Add Engine Oil:
1. Reinstall the oil drain bolt with the new sealing washer and tighten it
to the specified torque:
18 lbf·ft (25 N·m , 2.5 kgf·m)
2. Fill the crankcase with the recommended grade oil approximately:
3.0 US qt (2.8 )
3. Reinstall the oil fill cap/dipstick.
4. Start the engine and let it idle for 3 5 minutes.
5. Stop the engine, wait 2 3 minutes and check the oil level. Make sure
the oil is between the upper and lower level marks on the oil fill cap/
dipstick. If necessary, add more oil but do not overfill.
6. Check that there are no oil leaks.
7. Install the left side cover.
8. Install the seat.
If a torque wrench is not used for installation, see your dealer as soon as
possible to verify proper assembly.
Engine Oil & Filter
184 ).
Servicing Your Honda 113