Electrical Requirements; Location Requirements; Air Purifier Use; Starting/Stopping Your Air Purifier - Whirlpool Air Purifier Use & Care Manual

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Electrical Connection
To properly install your air purifier, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
The air purifier should be connected to a 115 V, 60 Hz, 15- or
20-ampere fused 3 prong grounded outlet.
The use of a time-delay fuse or time-delay circuit breaker is
recommended.

Location Requirements

1
1. 6 in. (15.2 cm) min. clearance
You will need a level surface at least 6 in. (15.2 cm) from heat
sources such as ranges or heaters.
Do not block the air openings or place the air purifier on a soft
surface such as a bed or sofa.
Operate indoors only.

AIR PURIFIER USE

Starting/Stopping Your Air Purifier

NOTE: Before operating the air purifier, record the date of
installation on the HEPA filter, which should be replaced annually.
The pre-filter should be replaced every 3 months. To remove and
replace either filter, see "Filter Replacement" in the "Air Purifier
Care" section.
1
2
3
1. Low fan speed 3. High fan speed
2. Medium fan 4. HEPA filter
speed indicator light
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Both filter indicator lights will flash once during a self-
test when the air purifier is turned on or after a power
interruption.
2. Turn the fan speed knob to the large fan icon (High), the
middle fan icon (Medium) or the small fan icon (Low) to select
the desired fan speed.
3. Turn the fan speed knob to Off to turn the air purifier off.
3
Change
4
HEPA Filter
Change
5
Pre-Filter
Filter
6
Reset
5. Pre-filter indicator
light
6. Filter Reset button