Category And Channel Search; Direct Access Tuning; Selecting The Preset Band; Channel Preset Memory - Kenwood KDC-MP832U Instruction Manual

SIRIUS tuner control features

Category and Channel Search

Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the Control knob.
2
Select the Category
Push the Control knob towards [FM] or [AM].
• It is the item when the category of Middle text display
part is selected.
3
Select the Channel
Push the Control knob towards [4] or
[¢].
• You cannot Channel search until the category
information is acquired.
Cancelling Category and Channel Search
mode
Press the Control knob.
Function of remote control

Direct Access Tuning

Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Push the Control knob towards [4] or
[¢].
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• You can set up until Channel number 223.
• If there is no signal in the input Channel, "No Channel"
appears. (KTC-SR901: optional accessory)
38
|
English
• You cannot search for a channel number which is not
broadcasting.
(KTC-SR902/KTC-SR903: optional accessory)
• If you cannot receive any signal in the input Channel
due to bad conditions on radio wave or other such
problems, "Acquiring Signal" appears.

Selecting the Preset Band

Push the Control knob toward [FM].
Each time you push the knob, the preset band
alternates between the SR1, SR2, SR3 and SR4.

Channel Preset Memory

Putting the channel in the memory.
1
Select the preset band
Push the Control knob toward [FM].
2
Select the channel to put in the memory
Push the Control knob towards [4] or
[¢].
3
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 11).
4
Put the channel in the memory
Press the desired [1] — [6] button for at least
2 seconds.
The preset number display blinks 1 time.
On each band, you can put 1 channel in the
memory on each [1] — [6] button.
• Only the channel number is stored. Category
information is not stored.