Direct Access Tuning; Station Preset Memory; Auto Memory Entry; Preset Tuning - Kenwood KDC-MP832U Instruction Manual

Function of remote control

Direct Access Tuning

Entering the frequency and tuning.
1
Select the band
Press the [FM] or [AM] button.
2
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
"– – – –" is displayed.
3
Enter the frequency
Press the number buttons on the remote
control.
Example:
Desired frequency Press button
92.1 MHz (FM) [0], [9], [2], [1]
810 kHz (AM) [0], [8], [1], [0]
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.

Station Preset Memory

Putting a station in the memory.
1
Select the band
Push the Control knob towards [FM] or [AM].
2
Select the frequency to put in the memory
Push the Control knob towards [4] or
[¢].
3
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 11).
4
Put the frequency in the memory
Press the desired [1] — [6] button for at least
2 seconds.
The preset number display blinks 1 time.
On each band, 1 station can be put in the
memory on each [1] — [6] button.

Auto Memory Entry

Putting stations with good reception in the
memory automatically.
1
Select the band for Auto Memory Entry
Push the Control knob towards [FM] or [AM].
2
Open Auto Memory Entry
Press the [AME] button for at least 2 seconds.
When 6 stations that can be received are put in
the memory, Auto Memory Entry closes.

Preset Tuning

Recalling the stations in the memory.
1
Select the band
Push the Control knob towards [FM] or [AM].
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 11).
3
Recall the station
Press the desired [1] — [6] button.
27
|
English