Satellite Radio Tuner (Optional Accessory) Control; Basic Operation; Category And Channel Search; Channel Preset Memory - Kenwood KDC-X494 Quick Start Manual

Satellite Radio tuner (Optional Accessory) control

Basic Operation

Selecting Satellite Radio source
Press the [SRC] button.
Select the "SIRIUS" or "XM" display.
For how to select source item, refer to
source selection> (page
⁄
• You need to register to the service provider to receive the
service by Satellite Radio. Consult the service provider if
"CALL ... TO SUBSCRIBE" appears.
• The radio may take a little time to start receiving after you
select the Satellite Radio source.
• If the signal reception fails, "Acquiring Signal"/ "No Signal"
appears.
Selecting the channel
Push the Control knob towards right or left.
Selecting the Preset Band
Push the Control knob toward up.
Each time you push the knob, the preset band
alternates between the SR1, SR2, SR3 and SR4.

Category and Channel Search

Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the [ ] button twice.
2
Select the Category
Turn the Control knob to select Category, and
then press the [ENTER] button.
3
Select the Channel
Turn the Control knob to select Channel, and
then press the [ENTER] button.
Cancelling Category and Channel Search mode
Press the [ ] button for at least 1 second.
⁄
• You cannot Channel search until the category information
is acquired.
26
|
KDC-X494/ KDC-MP445U/ KMR-440U
<Power and
4).

Channel Preset Memory

Putting the channel in the memory.
1
Select the channel to put in the memory
Push the Control knob towards right or left.
2
Enter Preset Memory mode
Press the [ ] button.
3
Select the number to put in the memory
Turn the Control knob.
4
Register channel to preset number
Press the [ENTER] button for at least 2 seconds.
Cancelling the Preset Memory mode
Press the [ ] button.
⁄
• Only the channel number is stored. Category information
is not stored.

Preset Tuning

Recalling the channels in the memory.
1
Enter Preset Tuning mode
Press the [ ] button.
2
Select a desired channel in the memory
Turn the Control knob.
3
Recall the channel
Press the [ENTER] button.
Cancelling Preset Tuning
Press the [ ] button.

Channel Scan

Every receivable Channel is checked for 10 seconds.
1
Start Channel Scan
Press the [S.MODE] button.
2
Release it when the channel you want to listen
to is received
Press the [S.MODE] button.