RIDGID TS3612 Owner's Manual page 47

D.These lines indicate the "path" of the
cut (kerf) made by the sawblade.
E.When cutting the workpiece, line up
mark on workpiece with line on disk.
NOTE: When the blade is changed, or a
dado/molding head installed these lines
will need to be erased and reset.
11. Micro-Adjust Rip Fence...
the operator to accurately adjust the
rip fence using only one hand. To
move the fence push in on the micro-
adjust knob and rotate.
The microadjust mechanism may be
converted to operate on the left hand
side of the fence. Simply remove two
Phillips head screws - rotate the
micro adjust mechanism 180° and
reinstall screws.
12. Herc-U-Lift™ Caster Operation
The caster set is activated by pressing
down on the metal platform. This will raise
the table saw and allow the saw to be
moved to desired location.
13. Storage Hooks
Conveniently holds rip fence and miter
gauge when not in use.
Using
Ind-I-Cut
allows
To lower the table saw, press down on the
foot pedal. Make sure the saw firmly rests
on the floor. Adjust the rubber leveling
feet if necessary.
Miter
Gauge
47
Micro Adjust
Knob
Rip Fence