Diagram Of Outdoor Unit Installation - Argo AE4MI91AH Technical & Service Manual

7-3. Diagram of Outdoor Unit Installation

Never install only a single indoor unit.
Be sure to connect indoor and outdoor units only in
combinations that are listed in the catalog or in the
combination table that was provided with the outdoor unit.
(Use caution. Connecting any other model may result in
operation failure and malfunction.)
The dimensions indicated by ⇔ in the figure below are
spaces that are required in order to maintain
performance. Install in a location where the dimensions
indicated by ⇔ are ensured, and where 2 or more faces
of the unit are unobstructed. In principle, the top direction
should be unobstructed.
Ensure 150 mm
of space if a
drain hose is to
be used.
Base (not provided)
(concrete or similar material)
Cable fastener
Inspection panel
Fasten with anchor bolts
(not provided)
(3/8" or M10, 4 locations)
Power breaker
A
B
C
D
Ground
wire
(not
provided)
Fig. 5
15
Indoor unit B
Indoor unit C
Indoor unit D
Service space
Unit: mm
Tubing
panel
Indoor unit A