Table of Contents
Advertisement
Channels: 2
Receiving freqs: 2.403 – 2.480GHz
Modulation: spread spectrum
Input power: four "AA" alkaline, NiCd or NiMH cells
Dimensions: 1.77 x 0.98 x 0.5" (45 x 25 x 13mm)
Weight: 0.25 oz (7g)
TROUBLESHOOTING
RANGE IS SHORT: Interference – check Rx installation and servo connections.
Low Tx or Rx battery – replace the batteries. Crash damage – send the radio
to Hobby Services for repair.
RUN TIME IS SHORT: Low Tx or Rx batteries – replace the batteries. Obstructed
servo linkages causing excess battery drain – free the linkages / pushrods.
Tx LED ON BUT SERVOS DO NOT FUNCTION: Rx batteries are low –
replace the batteries. Rx switch is in the off position – turn on the ESC or
switch harness. Switch harness or ESC is connected incorrectly – check
all connections and the ESC instruction manual. Rx is not binded to the Tx
properly – perform binding process again.
INTERFERENCE OR SERVOS GLITCHING: Out of range – operate the
model more closely to the transmitter. Outside radio interference (pagers, strong
industrial or other commercial transmitters in the area) – check your local R/C
club for confi rmation of dangerous / interfering frequencies in your area.
ONLY ONE SERVO GLITCHES: Servo is bad – replace the servo or send to
Hobby Services for repair.
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS
TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
RECEIVER
6
Advertisement
Table of Contents
