Related Manuals for Petsafe UltraSmart
Summary of Contents for Petsafe UltraSmart
-
Page 1: Receiver Collar
PetSafe UltraSmart ® ® Receiver Collar Operating and Training Guide Please read this entire guide before beginning. - Page 2 To get the most protection out of your warranty, please register your product within 30 days at www.petsafe.net. By registering and keeping your receipt, you will enjoy the product’s full warranty and should you ever need to call the Customer Care Center, we will be able to help you faster.
-
Page 3: How The System Works
Correction will be delivered through the Contact Points to get his attention until he returns to the Pet Area. Although harmless, this will discourage him from continuing further. Three adjustable levels of correction allow you to choose the one that is appropriate for your dog’s temperament. The PetSafe ® UltraSmart ®... -
Page 4: Prepare The Receiver Collar
(A). Check the tightness weekly. Charge the Receiver Collar Before you can begin using the Receiver Collar, you will need to charge it for 2-3 hours using the Receiver Collar Charger included with the UltraSmart In-Ground Fence . Additional ®... - Page 5 Replace the Receiver Collar in the charger for 5 seconds ™ and then remove. Do not touch the Contact Points. If the Receiver Collar continues to fail the ReadyTest , call the Customer Care Center. ™ www.petsafe.net...
- Page 6 PerfectFit Test for Collar Fit ™ This test is an added feature to verify fi t but is not required for the system to function. After the ReadyTest , the Receiver Collar will go into PerfectFit test mode. This mode ™...
- Page 7 Indicator Light will fl ash every 3 seconds to indicate the battery status as shown in the table below. Status Light Alarm Tone Condition While on Charger Solid Red No Tone Charge in progress Solid Green No Tone Charge complete No Light Charge failure, contact Customer Care Center www.petsafe.net...
- Page 8 After Removing From Charger ReadyTest & PerfectFit Test ™ ™ Off (1 second) No Tone Unit is performing ReadyTest ™ followed by Red (3 seconds) Continuous No Tone Battery Charge Indicator Green/Yellow/Red (5 seconds) Continuous Red 20 sec. ReadyTest ™ failure;...
- Page 9 Static Correction until he returns to the Pet Area. Run Through Prevention This system includes a unique “run-through” prevention so that your dog cannot escape the Pet Area without receiving an increased level of Static Correction. The Receiver Collar automatically increases the Static Correction when your www.petsafe.net...
- Page 10 dog continues more than ⁄ of the way through the pet fencing Field Width. For example, if the signal is detected 12 feet from the wire and your dog enters the Static Correction Zone, this feature is activated when he is approximately 8 feet from the Boundary Wire.
-
Page 11: Fit The Receiver Collar
A condition called Pressure Necrosis, which is a devitalization of the skin due to excessive and prolonged contact against the Contact Points, may occur if the steps above are not followed. www.petsafe.net... - Page 12 To assure a proper fi t, please follow these steps: Turn the Power OFF at the Fence Transmitter. Start with your pet standing comfortably ( Place the Receiver Collar on your pet so that the “PetSafe ” logo ® is right side up and the receiver is directly under your pet’s chin.
- Page 13 ReadyTest ™ . Do not touch the Contact Points during the ReadyTest . Place the collar on your pet and adjust the tightness until you ™ hear the 5 consecutive chimes, indicating a good fi t. www.petsafe.net...
-
Page 14: Taking Your Pet Out Of The Pet Area
Taking Your Pet Out of the Pet Area Important: Remove the Receiver Collar and leave it in the Pet Area. Once your pet learns the Boundary Zone, he will be reluctant to cross it for walks or car rides. Option 1: Replace the Receiver Collar with a regular collar. Put your pet in a car that is within the Pet Area and drive him out of the Pet Area. - Page 15 Pet Barrier systems are easy to operate ™ and you can use more than one to protect multiple areas. Purchase the Pawz Away Pet Barriers by visiting our website ™ at www.petsafe.net or by calling the Customer Care Center. www.petsafe.net...
-
Page 16: Additional Information
This system is not for vicious or aggressive pets. If your pet may pose a threat to others, DO NOT USE THIS SYSTEM. If you are unsure if your dog is aggressive, please consult your veterinarian or a certifi ed trainer. • The PetSafe UltraSmart In-Ground Fence is for residential use only. -
Page 17: Test Light Instructions
Hold the Test Light contacts to the Contact Points ( Hold the Receiver Collar at your dog’s neck height with the Contact Points pointing up (L) and the www.petsafe.net website on the receiver facing the Boundary Wire. Slowly walk toward the Boundary Wire until you hear the warning tone (M). -
Page 18: Troubleshooting
Troubleshooting Receiver Collar • Charge the Receiver Collar and go through the ReadyTest ™ is not beeping PerfectFit diagnostic tests. ™ or correcting. • Check that the Fence Transmitter Power is turned ON and the transmitter status light is solid green. If not, perform the “System Test”... - Page 19 Wire, perform the “System Test” (page 20). Receiver Collar • Check that the Receiver Collar is properly seated on the Collar is not charging. Charger with PetSafe ® logo facing up. • Verify that the contact on the Collar Charger is clean and that there is no coating on the Receiver Collar Contact Points.
-
Page 20: System Test
System Test The system test is used to determine cause of system problems that have not been addressed elsewhere in this guide. You will need a 10 foot piece of Boundary Wire with ⁄ inch of insulation removed from each end to use as a test loop wire. Follow the steps below to perform the system test: Remove the Receiver Collar from your dog and make sure it is fully charged. - Page 21 If there is a red fl ashing light with an alarm on the Fence Transmitter, there is a problem with the Surge Protector. Contact the Customer Care Center.) When testing is complete, return the Field Size and Field Width settings to their original position. www.petsafe.net...
-
Page 22: Terms Of Use And Limitation Of Liability
Terms of Use and Limitation of Liability Terms of Use This Product is offered to you conditioned upon your acceptance without modifi cation of the terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices. Proper Use This Product is designed for use with pets where training is desired. - Page 23 Relocate the interfered receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different to that to which the receiver is connected. • Contact the Customer Care Center. www.petsafe.net...
-
Page 24: Customer Care International
This device complies with Industry Canada Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 25 This product has the benefi t of a limited manufacturer’s warranty. Details of the warranty applicable to this product and its terms can be found at www.petsafe.net and/ or are available by sending a stamped addressed envelope to PetSafe ®...
- Page 26 Customer Care Center 1-800-732-2677...
- Page 27 www.petsafe.net...
- Page 28 Radio Systems Corporation ® 10427 Electric Avenue Knoxville, TN 37932 1-800-732-2677 www.petsafe.net 400-1135/1 Covered by US Patents 6,184,790; 6,327,999; 6,459,378; 6,807,720; 7,046,152; 7,068,174; 7,117,822; 7,204,204; 7,278,376; 7,345,588; 7,394,390; 7,404,379; 7,495,570; D522,187; D523,998; D535,902. Other Patents Pending. ©2009 Radio Systems Corporation...
Need help?
Do you have a question about the UltraSmart and is the answer not in the manual?
Questions and answers