Yaesu FT-991 Operating Manual page 72

Cw C
onvenienCe
c M
onteSt
t M p
ext eSSAge rogrAMMing
1. Press the MODE button to set the operating mode to
CW.
that Break-in is "Off" with [ BK-IN ]
2. Be sure
LCD, if necessary.
3. Press the FH-2 [ MEM ] key. A blinking "REC" icon
will appear in the display.
4. Press an FH-2 [ 1 ] ~ [ 5 ] key to select the desired CW
Memory Register into which you wish to program
the text, the blinking "REC" icon will disappear.
5. Use the FH-2 [ t ] and [  ] keys to set the cursor
position and use the FH-2's [ p ] and [ q ] keys to
choose the letter/number to be programmed in each
slot of the memory. In the case of the second ex-
ample on the previous page the "#" character desig-
nates the slot where the Contest Number will appear.
A :
dvice
You may also use the Main Tuning Dial knob and the
knobs to program the message characters.
MULTI
Page 70
f
k
eyer ( u
eMory
Sing the
on the
eaTures
o Fh-2 r
ptionAl
6. When the message is complete, add the "}" character
at the end to signify the termination of the message.
7. Press and hold in the FH-2 [ MEM ] key for one sec-
ond to exit, once all characters (including "}") have
been programmed.
c cw M
hecking the
1. Be sure that Break-in is still turned "Off" with [ BK-
IN ]
on the LCD.
Touch [ MONI ] on the LCD
2.
tor.
3. Press an FH-2 [ 1 ] ~ [ 5 ] key, whichever memory you
just recorded in. You will hear the results in the sid-
etone, but no RF energy will be transmitted.
o -t -A cw M
n he ir
1. Touch [ BK-IN ] on the LCD to enable transmission.
Either Full-break-in or Semi-break-in will be en-
gaged, depending on the setting of Menu item "063
CW BK-IN".
2. Press an FH-2 [ 1 ] ~ [ 5 ] key, depending on which
CW Memory Register message you wish to transmit.
The programmed message will be transmitted on the
air.
FT-991 O
c k
eMote ontrol eypAd
c
eMory ontentS
to enable the CW moni-
p
eSSAge lAybAck
M
peraTing
)
anual