Yaesu FT-991 Operating Manual page 66

Cw M
ode
The configuration of the Electronic Keyer may be customized independently for the front panel KEY jack of the
FT-991. This permits utilization of Automatic Character Spacing (ACS), if desired. This permits the use of an
electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel jack.
1. Press the MENU(SETUP) button to engage the
Menu.
2. Rotate the MULTI knob to select Menu item "011
KEYER TYPE".
3. Press the [ SELECT ] button, then rotate the
MULTI knob to set the keyer to the desired mode.
The available selections are:
The built-in Electronic Keyer is turned
OFF:
off ("straight key" mode).
Dots will be generated automatically
BUG:
by the keyer, but dashes must be sent
manually.
ELEKEY: Both dots and dashes will be generated
automatically when using a paddle.
Same as "ELEKEY" except that the spac-
ACS:
ing between characters is precisely set
by the keyer to be the same length as a
dash (three dots in length)
4. When your adjustments are complete, touch [ EN-
TER ] on the LCD to save the new setting.
5. Press the MENU(SETUP) button or touch
[ BACK ] on the LCD to exit to normal operation.
Page 64
o
peraTion
u b -
Sing the uilt
Selecting the Keyer Operating Mode
e k
in lectronic eyer
ACS
OFF
Morse
"E" & "T"
ACS
ON
Morse
"E" & "T"
FT-991 O
MENU(SETUP) Button
MULTI Knob
Inter-character
スペース
Spacing too short
M
peraTing anual