Nortel WLAN 2300 Series Installation And Configuration Manual page 51

• For connection to another switch, use a crossover cable. (For cable requirements, see
cables" on page
Note.
The 10/100 Ethernet ports on the 2360/2361 switches provide automatic
MDI/MDX.
2
If the cable is directly attached to an AP:
• For a first-time installation, set the port type to activate the link. (For information, see "Setting the
Port Type" in the
• If the port type is already set for an AP, observe the appearance of the AP LED for the port:
AP LED Appearance
Solid green
Alternating green and amber
Solid amber
Blinking amber
Unlit
3
If the cable is attached to a wired end station that uses AAA through the WSS to access the network:
• For a first-time installation, set the port type to activate the link. (For information, see "Setting a Port
for a Wired Authentication User" in the
• If the port type is already set for a wired authentication port, go on to
4
If the cable is directly attached to a device other than an AP:
a
Observe the appearance of the Link LED for the port:
Link LED Appearance
Solid green
Solid amber
Blinking green
Blinking amber
Unlit
Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
39.)
Nortel WLAN 2300 System Software Configuration Guide
Meaning
For an AP's active link, with PoE enabled, all the
following are true:
• AP has booted.
• AP has received a valid configuration from the
WSS.
• Management link with an AP is operational.
For an AP's secondary link, the link is present.
AP is booting with an image received from the WSS.
PoE is on, but no AP is connected to the link.
AP is unresponsive or there is a PoE problem.
PoE is off.
Nortel WLAN 2300 System Software Configuration Guide
Meaning
100-Mbps link is operational.
10-Mbps link is operational.
Traffic is active on the 100-Mbps link.
Traffic is active on the 10-Mbps link.
Link is not operational.
Installing and connecting a WSS 51
step 4.
"Network