Connection; Monitor Unit - Kenwood Excelon KVT-911DVD Instruction Manual

Installation

Connection

2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may start a fire. Always connect those wires to the
power source running through the fuse box.
Ignition key
switch
Car fuse
box
(Main fuse)
+
Battery
Connect to the vehicle's parking brake detection switch
harness using the supplied relay connector.
2 CAUTION
For the sake of safety, be sure to connect the parking sensor.
(AccessoryF)
When using the optional power amplifier, connect to its power
control terminal.
Depending on what antenna you are using, connect either to
the control terminal of the motor antenna, or to the power
terminal for the booster amplifier of the film-type antenna.
To "EXT.AMP.CONT." terminal of the amplifier having the
external amp control function.
58
ACC
A
B
A
Car fuse box
C B
C
To car light control switch
FM/AM antenna input
Receiver unit (front side)
To car light control switch
(Accessory B)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Dimmer control wire (Orange)
ILLUMI
Parking sensor wire (Green)
PRK SW
TO MONITOR UNIT
L R
FM /AM
ANTENNA
AV OUTPUT
L R
VIDEO
Ignition wire (Red)
A
Battery wire (Yellow)
B
Ground wire (Black) - (To car chassis)
C
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT
CONT
Dimmer control wire (Orange)
ILLUMI
External amplifier control wire (Pink / Black)
EXT.CONT.

Monitor unit

(Accessory C)
( 5A )
(Accessory E)
PREOUT
AV INPUT 1
L R
VIDEO FRONT REAR NON-FAD
L L L
2
AV INPUT
L R R R R
VIDEO
Wiring harness
(Accessory A)
( 3A )
( 10A )
Black
M 4
POWER