Cub Cadet 930 SWE Operator's Manual page 12

Adjusting Drive and Auger Controls
1. From beneath the handle, pull downward on the
appropriate cable and unhook the spring found on the end
of the cable from its respective actuator bracket. Refer to
Figures 3-13 and 3-14.
Figure 3-14
2. Slide the spring up the cable to expose the cable coupler
threads and lock nut. Refer to Figure 3-15.
Figure 3-15
3. Adjust the lock nut as follows: If adjusting the drive
cable, thread the lock nut outward (down the coupler) to
lengthen the cable and allow the unit to move freely when
the control is released. Thread the lock nut inward (up
the coupler) to shorten the cable to reduce slippage and
prevent the machine from being easily moved with the
drive control engaged.
WARNING!
Do not over-tighten the cable. Over-
tightening may prevent the auger from disengaging
and compromise the safety of the snow thrower.
4. If adjusting the auger cable, thread the lock nut down to
lengthen the cable as necessary to stop the auger from
turning when the control is released.
5. Securely hook each cable's spring into the appropriate hole
of the respective actuator bracket. The auger cable hooks
into the forward-most hole in the bracket, the drive cable
hooks into the rear-most hole of its bracket.
6. Repeat the wheel drive and auger control tests to verify
proper adjustment. Repeat previous steps if necessary to
attain proper adjustment of each cable.
s
ectiOn
3 — a & s -u
sseMbly et p
12