Cub Cadet 930 SWE Operator's Manual page 11

To adjust the skid shoes:
1. Adjust skid shoes by loosening the six (three on each side)
hex nuts, washers, and carriage bolts securing the skid
shoes to the auger housing. Refer to Figure 3-12.
Shave
Plate
2. While observing the distance between the shave plate and
the ground, adjust the skids shoes up or down to achieve
the desired shave plate height. See Figure 3-12.
3. Make certain the entire bottom surface of skid shoes are
against the ground to avoid uneven wear on the skid shoes;
then tighten nuts and bolts securely.
Auger and Drive Control Cables
WARNING!
carefully read and follow all instructions below.
Perform all adjustments to verify your snow thrower is
operating safely and properly.
Testing Auger Drive Control
1. When the au ger control is released and in the disengaged
"up" position, the cable should have very little slack. It
should NOT be tight. Refer to Figure 3-13.
11 s 3— a
ectiOn sseMbly
Lower
Shave
Plate
Raise
Shave
Plate
Figure 3-12
Prior to operating your snow thrower,
& s -u
et p
Chute Tilt Control
Auger
Control
Auger
Control
Cable
Figure 3-13
2. In a well-ventilated area, start the snow thrower engine as
instructed in Section 5 - "Operation" on page 13. Make sure
the throttle is set in the FAST position.
3. While standing in the operator's position (behind the snow
thrower), engage the auger.
4. Allow the auger to remain engaged for approximately ten
(10) seconds before releasing the auger control. Repeat this
several times.
5. With the throttle control in the FAST (rabbit) position and
the auger control in the disengaged "up" position, walk to
the front of the machine.
6. C onfirm that the auger has completely stopped rotating
and shows NO signs of motion. If the auger shows ANY
signs of rotating, immediately return to the operator's
position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
Testing Drive Control & Shift Lever
1. With the engine turned off, move the shift lever into sixth
(6) position. Refer to Figure 3-13.
2. With the wheel drive control released, push the snow
thrower forward, then pull it back. The machine should
move freely.
3. Engage the drive control and attempt to move the machine
both forward and back, resistance should be felt.
4. Move the shift lever into the fast reverse (R2) position and
repeat the previous two steps.
5. If you experienced resistance rolling the unit, either
when repositioning the shift lever from 6 to R2 or when
attempting to move the machine with the drive control
released, adjust the drive control immediately. See
Adjusting Drive and Auger Controls.
Shift Lever
Drive
Control
Drive
Control
Cable