JR 10X HELICOPTER VERSION User Manual page 56

Once any channel is designated for a fail-safe preset, your screen
will change to display the following:
Indicates whether
channel is in Fail-Safe
or Hold position
Indicates model number
Indicates function for which function is being
accessed
being accessed
1–8 correspond to channel numbers on receiver
Note: In the above example, only channel 1, throttle, has been
designated so far for fail-safe preset. You can observe this by not-
ing that the shaded portion of the box is in the upper, or fail-safe,
position.
To enter the preset servo positions you want, simply place the
switches (referring to
in the positions you want the servos to assume during signal loss
conditions. Next, touch the
channel has been selected for fail-safe, instead of hold signal,
position.
In the previous example, channels 2, 4, 6 and 8 were touched (as
is exhibited by the location of their shaded boxes) and need to
have preset positions input accordingly.
To select a preset fail-safe position, place the switch(es) and/or
gimbal sticks in the positions you want the servos to assume dur-
ing signal loss conditions. Next, touch the
appears once any channel is selected for fail-safe. When the
key is depressed, an audible beep sounds and
STORE
momentarily on the
LCD
The switch positions and/or stick positions are now stored in the
transmitter's memory circuit, to be sent automatically to the
receiver's memory.
To verify the input of the applicable fail-safe presets, turn the
power switch of the transmitter "off," while leaving the receiver's
power "on." Observe the reactions of the servos. The channels
that have been selected for fail-safe pre-set positions now assume
those positions, while the other channels hold their last clear sig-
nal position.
Note: These preset positions remain stored in the transmitter's
memory until both the transmitter battery pack and the lithium
back-up battery have been removed (or until Code 28, Data
Reset, has been performed). Therefore, you do not have to reset
the fail-safe each time you fly. Should you want to re-adjust the
fail-safe preset positions, simply access the Fail-Safe function
once again and adjust the presets as you have just done. The
transmitter automatically recalls the settings for the latest fail-
safe adjustment.
56
Touch
data and exit program
Touch
store Fail-Safe
preset position for
channels selected
3 and retracts) and the gimbal sticks
AUX
key that appears once any
STORE
key that
STORE
SET
display above the key.
STORE
to memorize
to
flashes
10X MANUAL Heli