HP procurve 420 Getting Started Manual page 37

Type password password to create a password for the manager, where
5.
password can consist of up to 8 alphanumeric characters and is case
sensitive.
HP ProCurve Access Point 420(config)#password 1AB2F
HP ProCurve Access Point 420(config)#
Type interface ethernet to access the Ethernet interface-configuration
6.
mode.
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#
Type show to display the access point's default IP configuration, including
7.
IP address, subnet mask, and default gateway. The following illustration
shows the default settings.
HP ProCurve Access Point 420(if-ethernet)#show
Ethernet Interface Information
========================================
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Speed-duplex
Admin status
Operational status
===========================================================
HP ProCurve Access Point 420(if-ethernet)#
To manually assign an IP address, first type no ip dhcp to disable DHCP
8.
client mode. Then type ip address ip-address netmask gateway, where
ip-address is the access point's IP address, netmask is the network mask
for the network, and gateway is the default gateway router. Check with
your system administrator to obtain an IP address that is compatible with
your network.
HP ProCurve Access Point 420(if-ethernet)#no ip dhcp
HP ProCurve Access Point 420(if-ethernet)#ip address 192.168.1.1
255.255.255.0 192.168.1.254
HP ProCurve Access Point 420(if-ethernet)#
Getting Started With Access Point Configuration
: 192.168.1.1
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
: 100Base-TX Full Duplex
: Up
: Up
3-3